Used Tube Laser
Let's see below the advantages of using an Automatic Tube and Section Bar Storage System with a Lasertube Cutting System.
The most productive solution to tubes of any section. Tubes upto O 6" (152.4mm).2D cutCO2 (or fiber laser).
Tube Lasers Cutting Systems Dallas Tx
How can you compensate? Traditionally, you would touch the contact points by coming down. Next, rotate the tube and touch the opposite side. This will give the control an indication about how bent the tube may be. This can be used to ensure that through-holes fit the application. Be aware that this reduces your ability to deliver very precise tolerances every time the tube rotates.
Tube and sheet metal cutting by a combined laser system. Tubes up O 4.72", 120 mm. Sheets up 236". x 79". (6000mm x 2000mm).Fiber Laser
Tube Laser Cutting Systems Reno Nv
Fiber lasers are 10 percent shorter than CO2 laser beams in wavelength. Because of its shorter wavelength, fiber lasers produce a beam that is easier to absorb by reflective materials. A CO2 laser's wavelength is less likely to reflect off these surfaces. This allows fiber laser cutting machines to cut brass, bronze, and other reflective material. A CO2 laser beam that reflects on the material can damage not only its cutting lens, but the entire beam path. This risk can be eliminated by using fiber-optic cables to guide the beam.
StarCut Tubes SL is a laser cutting system that provides high accuracy, superior reliability, as well as high performance for cutting complicated medical devices such stents.
3d-printed
StarCut Tube's tube-cutting laser machine StarCut Tube provides the highest precision and contour cutting accuracy, at a range of +/-5um.
Many believed fiber lasers could only work with thin materials. Because CO2 has a longer wavelength, it created enough material kerf to permit material removal. Fiber lasers can't produce the same level of kerf and results with thicker materials. This has been corrected by collimating tech, which can produce a wide fiber laser-generated beam that allows for materials separation. It also makes it possible to allow for material removal in thicker materials. You can also switch the beam width so that the machine can process thin materials with the narrower beam. This allows you to process more materials in a shorter time.
