METEOR-1200 can reduce the time it takes to drill or on-site assembly. METEOR-1200 can drill beams, angles and flat sheets of any geometry. The state-of-art control system allows you to mill slots, pockets, and any other geometry.
The basic unit comprises a semiautomatic, oxyfuel-fuel coping system. The operator positions the piece, fine tunes it, cuts the material, and adjusts the torch height. A laser can be used to automatically set the torch height and probe the material. The basic unit also comes with powered conveyors. These allow the operator the ability to manually measure the length of the feedstock and mark it before cutting. There is an optional automated measuring device that uses laser to measure the feed stock. The operator can input the material to be cut through the interface. Operator scrolls through a number of options via pictorial representations displayed on the computer touch screen. The computer is programmed to display all the dimensions of AISC structural Steel. A fully dimensioned, dimensional cope drawing is available to facilitate programming and save time. Operators have the option to override or customize input and they can save it as a new programming program, if required. DSTV exported diagrams can also be used to program the machine. The wireless remote control allows the operator to turn on, off and operate the equipment. The operator can freely view the equipment at any angle that is necessary to verify operation and maintain accuracy. The operator marks the material, then moves it to a suitable position. Finally, he clamps the material hydraulically so that it can be cut. The operator aligns his laser to the mark and starts the cycle. The torch turns on, preheating and heating the material. The operator initiates the process of cutting and finishes it as long the torch height is maintained.
