Job Editor Menu > Tools > Convert to

Converts a selected group of objects to gerber Flashes.

Command Sequence

1. Select all the drawn pads that you want to convert to a flash. (It doesn't matter if pads are different sizes).

Note: This function requires that you select objects before proceeding.

Note: For more information about object selection see Viewing & Selection Basics

2. Select menu: Tools | Convert To | Flash (Selective)...

3. Verify settings for New Flashes, and press OK.

4. Fab3000 will now convert all selected objects to gerber flashes.

Note: It's a good idea to make sure that your Draw and Flash colors are different colors respectively. This will make it easier to determine which draw pads have not been converted to flashes.