Job Editor Menu > Tools > Convert to

Converts drawn pads to gerber flashes.

Command Sequence

1. Select the drawn pad(s) that you want to convert to a flash.

Note: This function requires that you select objects before proceeding.

Note: For more information about object selection see Viewing & Selection Basics

2. Select menu: Tools | Convert To | Flash (Interactive)...

3. Verify settings for New Flashes, and press OK.

4. Fab3000 will now search for all objects similar to your original selection, and convert them to gerber flashes.

Note: Turn off any layers that you do not want to convert draws to flashes.

Note: It's a good idea to make sure that your Draw and Flash colors are different colors respectively. This will make it easier to determine which draw pads have not been converted to flashes.