After all the above work is completed, curing is an important part of concrete driveway installation. Concrete does not undergo a rapid chemical process to harden or strengthen it. It is crucial that this curing occurs in the best possible conditions. The weather is the most important factor. Curing is at its best when it is around 70 degrees and the surface is kept damp but not soaked. Curing in cooler weather will take longer. Curing times can be slowed down by soaking the surface in water during hot weather.
Concrete is not an easy material to install for large projects. Concrete driveways require a lot of labor. Professional installation is recommended for most people.


Concrete slabs require regular maintenance. Sealing is a must. Stains can be caused by oil and other fluids from vehicles that are hard to clean up.
Sealing your concrete driveway can be a great finishing touch that will keep it in top shape for longer. Sealing concrete driveways can prevent cracks, prolong their lifespan, and protect them from chemicals that de-icing agents. It may be included in the estimate by some contractors, but you should always verify. It costs approximately $0.50 to $2.50 to seal a driveway. You must seal any specialty stain you have chosen to protect it.

stamped concrete walkway contractors near me


The color of stamped concrete can be affected due to weathering, efflorescence, dirt, and traffic. It is possible to minimize color changes by regularly cleaning and sealing the concrete. It is possible to restore the concrete's original color even if it has lost its appeal due to years or neglect.

For the lowest upfront cost, stamped concrete is cheaper than poured concrete. Concrete is relatively inexpensive and can be used to cover large areas of land quickly.

stamped concrete walkway contractors near me
concrete repair arlington tx

concrete repair arlington tx


Pavers require some maintenance to be in top condition. Pavers are often sealed with sand in the spaces between them. These tiles might eventually become damaged or lose their seal, and will need to be resealed.


A driveway stained with stain can be a great choice if you like to coordinate design elements. Staining will add depth and texture and catch the eyes of all who pass by. A driveway stain can be applied for $6 to $12 per square feet. It is done while the concrete remains wet. Once it has dried, it can be polished or matted.

stamped concrete installers


Every concrete driveway is going to need to get replaced. They should last 30-40years, so this is not a costly expense. However there are signs to recognize when you need to plan a replacement driveway.

While permits aren't required in every case, they may be required to build a driveway. The city will usually waive permits if a concrete pron has been placed in a subdivision. Average permit prices range from $50 to $200, if not.

contractors plano tx

contractors plano tx



Pavers, however, require some upkeep to stay in good shape. Sand is used to seal the tiles in the spaces between pavers. This can eventually cause the tiles to become loose or fall apart, so they will need to have their seals reapplied.



For new driveways, it may be necessary to make the site ready for concrete pouring. Trees and other rocks will be removed. Uneven ground will also be leveled. Contractors will carefully grade the driveway if terrain is naturally sloped between the house and the street to ensure drainage. Site preparation may require heavy equipment, which will incur additional costs.

stamped concrete driveway cost




A few additional things to keep in mind when budgeting for concrete driveway prices. It is possible that the terrain will require extra work or materials in order to ensure a stable driveway. You may also need specialty designs at an additional expense.

The cost of concrete driveways is almost half labor. If the average cost is $4 to $7 per foot, then labor will usually make up $2 to $3 per foot and concrete costs the rest. It takes laborers to prepare the site, create the concrete forms and add rebar, then lay the concrete. Once the concrete has cured the forms will be removed.