Navigation:  Job Editor Menu > Add > Donut

Adds a Donut to the active design.

 

Note: No defined aperture is required.

 

 

Command Sequence

 

1. Select menu: Add  | Donut

 

2. Assign the active dcode.  The active Dcode combo box, is located in the Toolbar.

 

3. Assign the active layer.  The active Layer combo box, is located in the Toolbar.

 

Note: New objects will be placed on the active layer.  If the active layer is turned off, you will not be able to add the new object (until that layer is turned on).

 

4. Select the center point for the donut.

 

5. Select the hole radius for the donut.

 

6. Select the outer radius for the donut.

 

7. Repeat Steps 2-6

 

8. To exit Add Donut:  Right Click or press 'Esc' .

 

9. If the command is incorrect, you may Undo.

 

Note: To add donut to a net, see Learn Guide: Add/Remove Objects from a Net

Note: To add donut to a composite, see Learn Guide: Composites 101