Navigation:  Job Editor Menu > Fabrication > Create Fabrication Drawing

Creates a Fabrication drawing from a drill layer and board outline layer.

 

Note: All Layer Types must be defined.  To define layer types see Layers Table... and define all Layer Types before proceeding.

Note: At least one Drill Layer must be defined.  Please import a drill file or create a Drill Layer before proceeding.

Note: A Border Layer must be defined.  Please either import a file containing a PCB border or create a Border Layer before proceeding..

 

Command Sequence

 

1. Goto menu:  Fabrication | Create Fabrication Drawing...

 

2. Select Drill Layer

 

Note: If your design has more than one drill layer (for example: Blind/Buried Via's), repeat Create Fabrication Drawing and select the other drill file(s). Each time this command is run a new Fabrication Drawing is created.

 

3. Verify Units.

 

4. Enter PCB details such as Part Number, Revision, Notes, etc.

 

5. Click 'Next' when done.

 

6. Review and verify the hole chart description.

 

Note: You may change the symbols used for each drill hole and edit the text.

 

7. Click 'Next' when done.

 

The Fabrication Drawing will be created.