The connection to the module varies based on the type of module.
|
|
The port configurations of the modules contained in Table 1 are described in document [11]. The port configuration of the modules contained in Table 2 are described in document [12]. You must configure the ports properly or you will not be able to connect to the module. |
Connect the module to the PC, and then
click AutoConnect COM Port (
). The PY Console starts searching for available
COM Ports.
If the module belongs to the modules listed in Table 1, PY Console:
1. Sets #PORTCFG=3,3
2. Reboots the module connected.
3. Displays the result as shown in the figure below.
See document [11] to know the available port configurations managed with the AT#PORTCFG command.
|
MODULES |
|
HE910 Series |
|
UE910 Series |
|
UL865 Series |
|
CE910 Series |
|
DE910 Series |
Table 1: HE/UE/UL Series and #PORTCFG configuration
Fig. 1: PY Console after Module Checking
The default configuration of the module for #PORTCFG and #STARTMODESCR is as follows:
AT#PORTCFG?
#PORTCFG: 1,1
OK
AT#STARTMODESCR?
#STARTMODESCR: 0,10
OK
For more information about AT commands see document [6].
To connect to the module:
1. Select COM1 port.
2. Click
Connect COM Port (
). The
[COM1 Connect] message is displayed in the PY Console.
3. In the command area, type the following command to check that PORTCFG configuration is #PORTCFG: 3,3:
AT=PORTCFG?
If the module belongs to the modules listed in Table 2, the PY Console does not modify the #PORTCFG configuration and does not reboot the module.
See document [12] to know the available port configurations managed with the AT#PORTCFG command.
|
MODULES |
|
GE910 Series |
Table 2: GE910 Series and #PORTCFG configuration
To connect to the module:
1. Select COM1 port.
2. Click
Connect COM Port (). The
[COM1 Connect] message is displayed in the PY Console.
3. In the command area, type the following command to check that the PORTCFG configuration is #PORTCFG: 0,0:
AT=PORTCFG?
As shown in the following figure, the port configuration is #PORTCFG:0,0:
The default configuration of the module for #PORTCFG and #STARTMODESCR commands is as follows:
AT#PORTCFG?
#PORTCFG: 0,0
OK
AT#STARTMODESCR?
#STARTMODESCR: 0,10
OK
