How To Become A Sidemount Technical Scuba Diver Girl

Diving Gear

Take a look at these three options if diving classes and lessons are not what you desire or you need to decide where to go next.

1. Your personal informations (name, email, etc). 2. Pick the preferred date. 3. Click on the Submit button to ask questions or inquire.

How To Become A Sidemount Technical Scuba Diver Girl

To get started on Sidemount diving you don’t need more than an Open Water Diver. Mind you, it obviously helps to have good buoyancy and trim and you should be able to set up and handle your equipment comfortably by yourself. Sidemount diving will add a whole new dimension when it comes to equipment setup and skills.

Sidemount diving is a form of sidemount diving that originated in cave diving but has been incorporated into recreational and non-overhead diving over the years. Simply put, your tanks will be worn on your side instead of being attached to your back. The tanks attach to a Sidemount BCD with clips or bungee chords, allowing for maximum flexibility. It was this flexibility that cave divers used to be able to lift their tanks from the bottom underwater, making it easier to pass through tight spaces.

How To Become A Sidemount Technical Scuba Diver Octopus

Technical diving means that a diver is not allowed to reach the surface from any point during the dive. It could be due to a ceiling in the form of a cave/wreck or virtual ceilings created by decompression obligations. To avoid decompression sickness, you must perform mandatory stops on ascent when the NDL's are exceeded. This usually requires the use special equipment like Sidemounts and Twinsets. Twinsets and Sidemounts require special gas mixes, additional training, and twinsets/sidemounts to ensure that you can perform these stops correctly on ascent in order to maximize Nitrogen offgassing.

There are three parts to certification. Knowledge development, skill practice and open-water diving. You can do all three on your own, or take a break to complete one of them.

How To Become A Sidemount Technical Scuba Diver Octopus
How To Become A Sidemount Technical Scuba Diver Pictures

How To Become A Sidemount Technical Scuba Diver Pictures

Sidemount PCB can answer your questions regarding medical fitness to dive.

You will also learn how to use Sidemount regulators. Usually, you will have one regulator on a long hose as well as one regulator on a short hose with a necklace. Unlike your normal regs, Sidemount regs are also marked so you can easily distinguish which tank you are breathing from. During my training, this included a swivel joint for my short hose regulator. In addition, you will have 2 SPGs – one for each first stage.

How To Become A Sidemount Technical Scuba Diver Life

Decompression divers employ oxygen mixtures of all kinds to extend their time looking at wrecks and reefs on the ocean floor. While the sport diver may get two 15 minute bottom time dives at 100ft the decompression diver can cruise around for 60 minutes or more, getting the most bang for their buck.

Don't worry if you are worried about how everything will fit together. You will learn how to set up your Sidemount equipment. Also, how to measure and adjust your bungees and clips so your tanks stay in line next to your legs. Your instructor will guide you through all this!

How To Become A Sidemount Technical Scuba Diver 70
How To Become A Sidemount Technical Scuba Diver 70

We do not issue certification cards unless they are earned. The mere fact that you have taken part in a training course does not make you certified. There may be multiple certification agencies that offer certification cards for cave courses. C-cards typically cost $30 each depending on the agency. You can ask your instructor more.

One of the most significant innovations in equipment cave divers have seen since the beginning of this century has been the transition from backmounted to sidemount doubles. Many cave divers now sidemount. There may even be more open-circuit sidemount cave divers that backmount cave divers.

Buoyancy

Technical diving is fun, but not for those who want to dive deeper. Cave and decompression diving carry a greater risk. Dive planning and training are key to reducing this risk. These divers are held to a higher standard. To become a skilled diver, it will take practice. It is not possible to replace the time spent in water, no matter how much research you do. Divers will see that minimum standards are often exceeded by instructors during training courses. Technical training teaches diver redundancy. This allows problems to be solved at 1500ft in a cave, and then an exit can be made to the surface. Although it sounds scary and complicated, this is an essential aspect of diving in such an environment. Technical training is challenging, but also fun. The diver will have a golden ticket that opens up new areas of the world.

And of course, the book of Verna Van Schaik ‘Fatally Flawed – The Quest to be Deepest’, the one woman who succeeded to break the female world record in depth in Bushman’s hole in South Africa and how she god there.

Check our other pages :

Frequently Asked Questions

2-3 hours
Even with small cylinders, you can usually dive for 2-3 hours (rebreathers typically have two 2/3l cylinders or one 3/5l cylinder).