Navigation:  Job Editor Menu > File Menu > Open Folder

Automatically Loads Gerber and Drill data from a folder.

 

Command Sequence

 

1. Select menu: File | Open Folder

 

2. Select the folder you want to import, and press "OK".  The folder is instantly scanned and the all the contained Gerber, Drill, Netlist files are imported.

 

Note: Fab3000 will automatically determine the correct format and aperture rules necessary to bring in your gerbers with minimal effort. However, if you are aware of special circumstances regarding your gerber files (such as 274D gerbers using an Incremental type, End-Block-Character other than "*", etc) or you've had previously imported gerbers load correctly, you may want to use AutoLoad.

 

Note: To view the Import log file, press key 'F2'