Plans For Toy Box Bench,Scroll Saw Fretwork Clock Patterns,The Woods Austin Tx Reviews,Thin Wood Wall Panels - PDF 2016

The box design is take from simple New England six plank boxes but uses the new edge glued board product to replace the no longer available wide wooden planks. There is also a simple version of this design available that depends on glue, blocks, and screws for the box joints. The back and arm rests features pre-made spindles and can be removed if the box must be shipped.
You can buy all the materials for this box at your local home store or mail order the spindles and piano hinge and Toy Box Supports from:. The drawings for one version this project are also available directly on the site in an Adobe .DPF file as an example of our plan drawings. The side view shows the arm rest (also with spindles) the recessed bottom for the casters, the end of the internal tray, and the curve the lid makes when opened. This sketch is shows the wide factory glued up boards used for the front, back, top, and ends. These are the pieces of wood and plywood needed for the bottom, tray, and secret compartment. The secret compartment is a wide but very thin compartment that fits between the casters underneath the box.
This is a full scale out line for a flower that can be either carved using a single gouge (see below) or cut-out and stenciled on. This is a full size pattern for a dovetail gage to help you make the course dovetails used for the corners of the box (details below).


This box uses four commercial edge-glued pine panels, plywood, and dimensioned pine lumber. With only slight modification of the drawings, this box can be made slightly smaller out of 16 by 48 inch panels. This box was designed to be build using only a few hand tools that a home owner might have, purchase at reasonable cost, or borrow. We have a number of other flower designs that can be used for either carving or paint stencils.
Dovetail joints are classic for this type of box, look great, and are very strong but do take a little hand work. Drill holes for the 15 finishing nails in the four joints using a common #6 finishing nail. Install the hinge with a few screws and trim the lid and the back piece to fit the top of the box. Two coats of polyurethane should last for many years but you may want to use three for heavy usage. You can decorate the box by caring in a simple pattern, stenciling, or simply painting it many colors.
It can slide front to back and hold small things that would otherwise be lost at the bottom of the box. These tools are all useful for general around-the-house maintenance and can fit in a tool box.


Fit the two outside pieces for uprights, cut the notch for the top board, and cut-out the box top. When you have it where you want it, drill bolt holes and counter sinks for the back arm bolts.
Nail and glue a straight piece of .75 inch square stock inside this for the tray to slide on. Toy Box Lid Supports are include to reduce the chance of little fingers being hit as the lid closes. Glue and nail small blocks around the inside of the box to hold the bottom in place so that casters stick down 1 inch.
You may choose instead to simply stenciled decorations on the box or paint it several colors like a circus wagon. Drill two finger holes in the compartment bottom and two pencil sized holes in the box bottom near the magnetic latches so the compartment can be pushed open from the inside if necessary.



Craft Projects With Wooden Letters
Outdoor Garden Bench Plans Free
Selling used woodworking equipment