14 Aug. 1983|
Wood turned articles,making wooden boxes with a router,swing set plans diy free,popsicle bridges that hold a lot of weight - Test Out
This project is a fun one; not only because it's a good turning project but also because it's a very functional item making it great for yourself or for gifts. They can be hollowed out of a solid block of wood but in this one I chose to use the glued up Stave method and chose cherry and walnut for this one. I've now reversed our blank and put its top into my chuck in expansion mode before cleaning up and then parting off the excess wood at the bottom. We update our home page about monthly to feature a new project, a new article, and a new and hot tool.
It turned out to be far more complicated than I had anticipated so heavy doses of perseverance were required. Now we're getting somewhere; the outside is turned, the inside of the horn has been shaped and I've drilled to the final depth of the piece. I like to glue the bottom of the cup to the wood using epoxy and then using silicon sealer around the lip to keep it watertight. I've cut them on the table saw, just by adjusting the tablesaw to cut my wood blanks at 22.5 degrees.
So there it was a cradle with its design basis fully anchored in woodturning, it was too cool.