12 Mar. 1983|
Building wood stairs over concrete,essential woodworking tool list,storage wood bench,wood drawers for sale - For Begninners
When laying down additional rows of wood, you need to leave a bit of space between them to allow for the wood's expansion and also for proper water drainage. Install the boards with a bit of an overhang at the edge of the floor, as this will all be cut off in one shot at the end.
Finally, make sure you pre-drill all holes so the screws don't end up stretching and potentially cracking the wood. As you can see the canopy is setup right next to the stairs and it needed to be tethered down so it would not fly away. My frame was a hair wider than 36in to catch the stringers, with very little left over so there would not be a blob of concrete on the sides. After the concrete was to the top of the frame I screed it with a 2X4 and then used an edging tool to help round the corners.
This entry was posted in Uncategorized and tagged amazon, american made, background, building, canopy, cheap, clever, common, concrete, concrete pad, deck, deck screws, difficuly, digging, DIY, DIYGEEK, easy, expensive, fall, frugal, galvanized, garage, geek, gravel, home, items, joist, joist hangers, landscaping, level, measurement, metal, nails, outside, pad, post, posts, premium, pressure, pressure treated, quality, quickrete, quickrete concrete, quikrete, quikrete concrete, quikrete pad, railing, review, safe, screen, screws, secure, simple, spring, stairs, steps, stringers, strong, sturdy, summer, tread, weak, weather, yard by thediygeek.
The board is thick and won't flop everywhere, so just hold it up against the sides of the staircase and crease it along the edges of the steps in order to know where to cut them. You can then quickly remove the stair boards to apply silicone where the skirts touch the concrete, and put the boards back on. Overall I’m surprised that this passed inspection, actually I am surprised I was able to walk on these without falling! I put a 2X8 PT ledger in place of the notched one.I fastened it with a combination of Tapcon Concrete Screws and deck screws. Wood will have a tendency to bend (over time) in the direction of those lines, so it's crucial to install the boards with those curves facing down.
Taking two stringers at the end and a placement ledger I cut a 2X4 to 33 inches so I could find out where my concrete pad would need to go.
Making sure to push into the mix to eliminate any air bubbles and to mix the concrete into the gravel base. Being screwed onto a firm surface will hold that cupping back, and if you install the board with the curves facing up its edges will rise over time and become both unsightly and dangerous (easy to trip over).
Make sure to use galvanized nails as regular nails will corrode with the pressure treated wood!