If you have more than one module connected, there is no way to specify which module to auto-connect to. Either leave only one module connected, or use the manual procedure.
With the Release configuration selected, you can click the Run button. This will automatically do the following:
1. Compile the project for the module
2. Search for and connect to an available port of the module
3. Copy the application to the module
4. Instruct the module to start the application
|
|
If you have more than one module connected, there is no way to specify which module to auto-connect to. Either leave only one module connected, or use the manual procedure. |
The build bar looks like this:
|
|
The Debug option will not work for the module. |