).
The AZ C Console starts searching for available COM Ports.To run the application on the module:
1. In the Tool pane, open the AZ C Console.
2. Click
AutoConnect COM Port ().
The AZ C Console starts searching for available COM Ports.
3. If the module is not connected, you can:
a. Click
Settings (
). The Settings
window opens.
b. In the COM Port field, select the COM port to which the module is connected. Usually COM12.
c. Click OK to close the Settings window.
d. Click
Connect COM Port (
) to
connect to the module. The AZ C Console displays a message if the connection
succeeds.
