REDmote v9.0.3 Firmware                            April 4, 2014

IMPORTANT: 
* Please use the updated installers in the DSMC Resources package (Mac and Windows)
* You will not be able to roll back to earlier firmware revisions than v2.0.13 after installing v9.0.3
* Camera Firmware v5.2.7 or later is required to be functional. 

Installation Instructions:
* Windows instructions for manual network setup
  - Open Internet Protocol (TCP/IP) properties for the REDmote connection (RNDIS Gadget)
  - Select 'Use the following IP Address' and enter 192.168.0.1 with subnet mask 255.255.255.0. Click OK.
  - Click OK to apply and exit Network Properties.
  - Disconnect REDmote from the PC and wait 5 seconds.
  - Reconnect REDmote to the USB Port and wait for Network to indicate connection
  - Complete the REDmote Upgrade
  - Restore the DHCP setting for the Network Connection after upgrade is complete
    - Open Internet Protocol (TCP/IP) properties for the REDmote Connection (RNDIS Gadget)
    - Select 'Obtain an IP Address Automatically' and select OK.
    - Select Close to exit Network Properties.
    - Disconnect REDmote from the PC
  - Upgrade and system configuration is complete
* Mac instructions for manual network setup
  - Go to your Network and find the device titled RNDIS/Gadget.
  - Select 'Manually', enter IP address 192.168.0.1 and Subnet Mask 255.255.255.0 and click Apply.
  - Start REDmote Upgrade Utility and upgrade.
  - Restore the DHCP setting after the upgrade is complete.
    - Go to your Network and find the device titled RNDIS/Gadget.
    - Select 'Using DHCP' and click Apply
  - Upgrade and system configuration is complete
* Contact RED if you are unable to connect using the manual instructions (http://www.red.com/contact_us).

Significant changes since previous build v8.0.12:
* Support REDgamma4/DRAGONcolor layout

Operational notes specific to build v9.0.3:
* None

Copyright (c) 2014 RED Digital Cinema, All Rights Reserved.