|
Drill Hit |
  
|
|
Drill Hit |
|
Adds Drill Hit to the active design.
Note: At least one NC Tool must already be defined.
Command Sequence
1. Select menu: Add | Drill Hit. The Add Drill Hit dialog box will appear.
2. Assign the NC Tool to use. Press OK to start.
3. Assign the active layer. The active Layer combo box, is located in the Toolbar.
Note: The Drill hit will be placed on the active layer. The active layer must be defined as a type: NC_PRIMARY or NC_SECONDARY.
4. Select the center point for the Drill Hit.
5. Repeat Step 4.
6. To exit: Right Click or press 'Esc' .
7. If the command is incorrect, you may Undo.