|
Copper Balancing |
  
|
|
Copper Balancing |
|
Copper Pour.
Note: The Active Layer must be displayed before Copper Balancing can be performed. You should only turn on one layer.
Online Movie: Using FAB 3000 to add copper with clearances
Command Sequence
1. Select menu: Fabrication | Copper Balancing....
2. Verify the Clearance. This is the distance the copper will keep between itself and other objects.
3. Verify the Minimum Size.
Note: Make sure you select the appropriate Silkscreen & Mask layers. A common mistake occurs when a user selects a Top Silkscreen against a Bottom Mask.
4. Press OK, and select the boundary to use for Copper Balancing. All copper will be placed on the active layer.