|
Flash |
  
|
|
Flash |
|
Adds a Flash the active design.
Note: At least one aperture must have been previously defined.
Note: The Flash will be placed on the active layer.
Command Sequence
1. Select menu: Add | Flash.
2. Assign the active dcode. The active Dcode combo box, is located in the Toolbar.
3. Assign the active layer. The active Layer combo box, is located in the Toolbar.
Note: New objects will be placed on the active layer. If the active layer is turned off, you will not be able to add the new object (until that layer is turned on).
4. Select the center point for the flash.
5. Repeat Steps 2-4.
6. To exit Add Flash: Right Click or press 'Esc' .
7. If the command is incorrect, you may Undo.
Note: To add this object to a composite, change the value in the pull-down "Composite Level". This pull-down becomes available when you activate a drawing command.