|
Donut |
  
|
|
Donut |
|
Adds a filled Donut to the active design.
Command Sequence
1. Select menu: Add | Donut
2. Assign the active layer. The active Layer combo box, is located in the Toolbar.
Note: New objects will be placed on the active layer. If the active layer is turned off, you will not be able to add the new object (until that layer is turned on).
3. Select the center point for the donut.
4. Select the hole radius for the donut.
5. Select the outer radius for the donut.
6. Repeat Steps 2-5
7. To exit Add Donut: Right Click or press 'Esc' .
8. If the command is incorrect, you may Undo.
Note: To add this object to a composite, change the value in the pull-down "Composite Level". This pull-down becomes available when you activate a drawing command.