B223B-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram Refer to Section 8W.

When Monitored:
Anytime the ignition key is in the ON position.
Set Condition:
If the Intrusion Transceiver Module configuration does not match the Intrusion Sensor(s) installed in the vehicle.

Possible Causes

INTRUSION TRANSCEIVER MODULE CONFIGURATION

Diagnostic Test

1. CONFIGURE THE INTRUSION TRANSCEIVER MODULE

NOTE: Before proceeding check the vehicles Intrusion Sensor(s) for the correct part number for this vehicle and replace if necessary.

Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.
With the scan tool, clear DTC(s).
Turn the ignition off and remove the key from the ignition.
Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
Disarm the VTSS.
Using the scan tool, read ITM DTC(s).

Does the DTC reset?

Yes

Replace the Intrusion Transceiver Module in accordance with the Service Information.

Perform BODY VERIFICATION TEST – VER 1 (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

No

DTC is not active at this time. Test complete.
Perform BODY VERIFICATION TEST – VER 1 (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)