B223D-OCCUPANT CLASSIFICATION MODULE DTC PRESENT

When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the ORC receives a bus message with the active OCM DTC Present bit set.

ACTIVE DTC IN OCCUPANT CLASSIFICATION MODULE (OCM)

Diagnostic Test

1. VERIFY THAT DTC B223D-OCCUPANT CLASSIFICATION MODULE DTC IS ACTIVE

With the scan tool, read the ORC active DTCs.

Does the scan tool display active: B223D-OCCUPANT CLASSIFICATION MODULE?

Yes

Go To 2

With the scan tool, perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.

2. ACTIVE DTC IN OCCUPANT CLASSIFICATION MODULE

With the scan tool, read the OCCUPANT CLASSIFICATION MODULE active DTC.

Are there any active DTC present?

Yes

Refer to the symptom list for problems related to the OCM.

Go To 3

3. REPLACE THE OCCUPANT RESTRAINT CONTROLLER

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

If there are no possible causes remaining, view repair.

Repair

Replace the ORC in accordance with Service Instructions.
Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.