DESCRIPTION
|
SPECIFICATION
|
FUEL TANK - 3.8L Gas Engine - 2 door models
|
18.6 U.S. Gallons (70.4 Liters)****
|
FUEL TANK - 2.8L Diesel Engine - 2 door models
|
17.6 U.S. Gallons (67 Liters)****
|
FUEL TANK - 3.8L or 2.8L Diesel- 4 door models
|
23 U.S. Gallons (87 Liters)****
|
ENGINE OIL
|
Engine Oil - with Filter - 3.8L
|
5.7 L (6 Quarts)
|
Engine Oil - with Filter - 2.8L
|
6.6 L (7 Quarts)
|
ENGINE COOLANT
|
Cooling System - 3.8L
|
12 L (13 Quarts)
|
Cooling System - 2.8L Diesel
|
12 L (13 Quarts)
|
POWER STEERING SYSTEM
|
Power steering fluid capacities are dependent on engine/chassis options as well as steering gear/cooler options. Depending on type and
size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these capacities may vary. Refer to 19, Steering for proper fill and bleed procedures.
|
A/C REFRIGERANT SYSTEM
|
Single Unit
|
0.51 kg (1.125 lbs)
|
AUTOMATIC TRANSMISSION
|
Service Fill - 45RFE/545RFE
|
4X2 - 5.2 L (5.5 Quarts)
|
4X4 - 6.2 L (6.5 Quarts)
|
|
Overhaul - 45RFE/545RFE
|
14-16 L (14.8–16.9 Quarts)♦
|
Service Fill - 42RLE
|
3.8 L (8.0 Pints)
|
Overhaul Fill - 42RLE
|
8.3 L (17.6 Pints)♦
|
♦Dry fill capacity. Depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary
cooler, these figures may vary
(Refer to 21 - TRANSMISSION/AUTOMATIC - 42RLE/FLUID - STANDARD PROCEDURE)
(Refer
to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE/FLUID - STANDARD PROCEDURE).
|
TRANSFER CASE
|
NV241
|
2.0 L (4.2 Pints)
|
MANUAL TRANSMISSION
|
NSG 370 Approximate dry fill or fill to bottom edge of the fill plug hole.
|
1.5 L (3.17 Pints)
|
FRONT AXLE +/- .03 L (1 oz.)
|
186 FBI (Model 30)
|
1.0 L (2.1 Pints)
|
216 RBI (Model 44)
|
1.3 L (2.7 Pints)
|
REAR AXLE +/- .03 L (1 oz.)
|
198 RBI (Model 35)
|
1.83 L (3.8 Pints)
|
226 RBI (Model 44)
|
2.25 L (4.75 Pints)*
|
* Trac-lok add 0.1 L (3.4 oz.) of Limited Slip Additive.
|
****Nominal refill capacities are shown. A variation may be observed from vehicle to vehicle due to manufacturing tolerance and refill
procedure.
|