INSTALLATION

NOTE: Full door shown, half door similar.

1. Assemble gasket (1) onto lock cylinder (2) until fully seated.
2. Install lock cylinder (2) into hole in outer door panel.

NOTE: Cylinder post must point forward.

NOTE: Cylinder drain hole must point down.

3. While holding lock cylinder (2) in place slide retainer clip (3) onto lock cylinder.

NOTE: Visually verify that pin on lock cylinder is engaged with bell crank 0n door module at door module install.

4. Install the latch (5), (Refer to 23 - BODY/DOOR - HALF FRONT/LATCH - INSTALLATION).