B1A25-INVALID KEY
For a complete wiring diagram Refer to Section 8W.
-
When Monitored:
At ignition on and during Key Programming Mode.
-
Set Condition:
When the SKREEM does not receive a transponder response after 8 consecutive transponder read attempts within 2.0 seconds. When the key that is being used is programmed for a different vehicle.
Possible Causes
|
KEY THAT HAS BEEN PREVIOUSLY PROGRAMMED FOR ANOTHER VEHICLE
|
MULTIPLE KEY OPERATION
|
IGNITION KEY
|
SKREEM
|
INTERMITTENT WIRING HARNESS PROBLEM
|
Diagnostic Test
1.
DETERMINING IF DTC IS CURRENT
NOTE:
Verify the key being used is the proper key for this vehicle and a blank key. If the key being programmed is not blank (one that has been programmed for another vehicle) this
fault will set.
With the scan tool, read and record the SKREEM DTCs.
With the scan tool, erase the SKREEM DTCs
NOTE:
Perform the following test several times to ensure the DTC is current.
Turn the ignition off.
Wait 10 seconds.
Turn the ignition on.
With the scan tool, read the SKREEM DTCs.
Does the scan tool display the DTC that was previously erased?
Yes
No
2.
CHECKING FOR MULTIPLE KEYS
Are there multiple vehicle ignition keys available?
Yes
No
3.
MULTIPLE KEY OPERATION
NOTE:
Perform the following steps using one of the vehicle ignition keys. When finished, repeat the procedure using each of the other vehicle keys, one at a time.
With the scan tool, erase the SKREEM DTCs.
Turn the ignition off.
Wait 10 seconds.
Turn the ignition on
With the scan tool, read the SKREEM DTCs.
Is the DTC present for all ignition keys?
Yes
-
Replace and program the Sentry Key Remote Entry Module in accordance with the Service Information.
-
Perform SKREEM VERIFICATION TEST.
No
-
Replace the ignition key(s) that cause the SKIM DTC.
-
Perform SKREEM VERIFICATION TEST.
4.
REPROGRAM KEY
With the scan tool, attempt to reprogram the ignition key to the SKREEM.
With the scan tool, erase the SKREEM DTCs.
Wait 10 seconds.
Turn the ignition on.
With the scan tool, read the SKREEM DTCs.
Does the DTC set again?
Yes
No
5.
PROGRAM NEW IGNITION KEY
Replace the ignition key with a new key.
With the scan tool, program the new ignition key to the SKREEM.
With the scan tool, erase the SKREEM DTCs.
Turn the ignition off.
Wait 10 seconds.
Turn the ignition on.
With the scan tool, read the SKREEM DTCs.
Does the DTC set again?
Yes
-
Replace and program the Sentry Key Remote Entry Module in accordance with the Service Information.
-
Perform SKREEM VERIFICATION TEST
No
6.
INTERMITTENT WIRING HARNESS PROBLEM
Turn the ignition off.
NOTE:
Check the following items:
-
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
-
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
-
Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?
Yes
-
Repair wiring harness/connectors as necessary.
-
Perform SKREEM VERIFICATION TEST
No