B222C-VEHICLE CONFIGURATION NOT PROGRAMMED

For a complete wiring diagram Refer to Section 8W.

When Monitored:
Continuously
Set Condition:
The TIPM is not configured for the vehicle.

Possible Causes

Diagnostic Test

1. CHECK FOR ACTIVE DTC

Turn the ignition on.
With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

Go To 2

No

Test complete.

2. ACTIVE TIPM DTC

Cycle the ignition from off to run remaining in run.
With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

Go To 3

No

Test complete.

3. VIN MISMATCH DTC PRESENT

Turn the ignition on.
With the scan tool, read DTCs.

Is DTC: B2206-CURRENT VIN MISSING / MISMATCH also active?

Yes

Refer to repair procedure for DTC-B2206-CURRENT VIN MISSING / MISMATCH. (Refer to 8 - ELECTRICAL/IGNITION CONTROL - DIAGNOSIS AND TESTING)

No

Replace the TIPM in accordance with the service information.
Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)