B219F IGNITION OFF DRAW (IOD) FUSE BLOWN

For a complete wiring diagram Refer to Section 8W.

When Monitored:
With the ignition on. This DTC will only set if vehicle has over 50 miles on it.
Set Condition:
IOD Fuse not installed or blown.

Possible Causes

IOD FUSE NOT INSTALLED

Diagnostic Test

1. CHECK FOR ACTIVE DTC

With the scan tool, record and erase DTC's.
Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
With the scan tool, read the active DTC's.

Does the scan tool display this DTC as active?

Yes

Go To 2

No

If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. IOD FUSE

Verify IOD Fuse installed in TIPM.

Is IOD Fuse present?

Yes

Go To 3

No

Replace the IOD Fuse.
Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

3. IOD FUSE BLOWN

Verify IOD Fuse is blown.

Is IOD Fuse blown?

Yes

Using the wiring diagrams, diagnose for a short to ground condition.

Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)

No

Test complete.