B2142 IGNITION OFF DRAW (IOD) FUSE NOT PRESENT
For a complete wiring diagram Refer to Section 8W.
-
When Monitored:
With the Ignition on. This DTC will set only if vehicle has less that 50 miles on it. After 50 miles, DTC B219F will set.
-
Set Condition:
IOD Fuse not installed in the TIPM.
Diagnostic Test
1.
CHECK FOR ACTIVE DTC
With the scan tool, record and erase DTC's.
Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?
Yes
No
-
If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors.
Look for broken, bent, pushed out, or corroded terminals.
2.
IOD FUSE INSTALLED
Verify IOD Fuse installed in TIPM
Is IOD Fuse present?
Yes
No
3.
IOD FUSE BLOWN CHECK
Is IOD Fuse blown?
Yes
No