B142C-VES VIDEO SCREEN DISCONNECTED
For a complete wiring diagram Refer to Section 8W.
-
When Monitored:
With the ignition on and the Radio in Video mode.
-
Set Condition:
With the Radio in Video mode, the Radio does not detect a VES Video Screen.
Possible Causes
|
BAD VES VIDEO SCREEN CONNECTION
|
RADIO
|
Diagnostic Test
1.
TEST VES VIDEO SCREEN CONNECTION
Turn the ignition off.
Disconnect the VES Video Screen connector.
Inspect the VES Video Screen connection.
Was the VES Video Screen connection clean and secure?
Yes
No
2.
VES VIDEO SCREEN
Refer to the Audio System in the Service Information and test the VES Video Screen in accordance with the Service Procedure.
Is the Antenna ok?
Yes
No
3.
RADIO
NOTE:
Reconnect all previously disconnected components.
NOTE:
Move vehicle outside approximately 30ft (9.14m) from any structure.
Turn the ignition on.
Turn the Radio on.
With the scan tool, clear all DTC's, put the Radio in mode.
With the scan tool, read DTC's.
Does the scan tool display active: B142C-VES VIDEO SCREEN DISCONNECTED?
Yes
No