INSTALLATION

NOTE: The following procedure applies only to the washer reservoir used with an optional diesel engine. The washer reservoir for vehicles with a gasoline engine is integral to the molded plastic component tray on the left side of the engine compartment.

1. Check to be certain that the U-nut (8) is in good condition and properly installed in the top of the radiator fan shroud (1).
2. Position the washer reservoir (3) into the left front corner of the engine compartment.
3. Align and engage the integral T-tab (4) on the front of the reservoir and the two integral tabs (7) on the bottom of the reservoir with their respective slots in the shroud.
4. Install and tighten the screw (2) that secures the integral mounting tab on the top of the reservoir to the U-nut on the top of the shroud. Tighten the screw to 9 Nm (79 in. lbs.).

NOTE: Be certain to reconnect the front and rear washer hoses to the proper outlet nipples from the washer pump. Failure to properly connect the hoses will cause the front and rear washer systems to operate incorrectly.

5. Reconnect the front and rear washer hoses (6) to the washer pump on the outboard side of the reservoir.
6. Reconnect the engine compartment wire harness connector to the washer pump/motor unit (5).
7. Refill the washer reservoir with the washer fluid drained during removal.
8. Reconnect the battery negative cable.