OPERATION

The front fog lamp indicator gives an indication to the vehicle operator whenever the front fog lamps are illuminated. This indicator is controlled by a transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Totally Integrated Power Module (TIPM) over the Controller Area Network (CAN) data bus.

The front fog lamp indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will allow this indicator to operate whenever the instrument cluster receives a battery current input on the fused B(+) circuit. Therefore, the LED can be illuminated regardless of the ignition switch position. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn ON the front fog lamp indicator for the following reasons:

The TIPM continually monitors electronic exterior lighting request messages from the ElectroMechanical Instrument Cluster (EMIC) to determine the appropriate outputs to the front fog lamps. The TIPM activates or deactivates the front fog lamps then sends the proper lamp-ON or lamp-OFF message back to the EMIC.

For proper diagnosis of the front fog lamp system, the TIPM, the EMIC, the CAN data bus or the electronic communication related to front fog lamp indicator operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.