U0161-LOST COMMUNICATION WITH COMPASS MODULE





For a complete wiring diagram Refer to Section 8W.



Possible Causes
(D506) LIN BUS CIRCUIT OPEN
(F921) FUSED IGNITION SWITCH OUTPUT (RUN) CIRCUIT OPEN
(Z916) GROUND CIRCUIT OPEN
COMPASS MODULE
INSTRUMENT CLUSTER




Diagnostic Test

1. CHECK FOR AN ACTIVE DTC

NOTE: Remove any electronic devices (laptop computers, cell phones) from the instrument panel.

NOTE: Before proceeding, check the compass variance and calibration in accordance with the service information.


Turn the ignition on.
With the scan tool, record and erase DTCs.
Wait 30 seconds.
With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes


No

2. (D506) LIN BUS CIRCUIT



Turn the ignition off.
Disconnect the Compass Module harness connector.
Turn the ignition on.
Measure the voltage of the (D506) LIN BUS circuit.

Is the voltage above 5 volts?

Yes


No

3. (D506) LIN BUS CIRCUIT OPEN



Turn the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Measure the resistance of the (D506) LIN BUS circuit.

Is the resistance below 10K ohms?

Yes


No

4. (F921) FUSED IGNITION SWITCH OUTPUT (RUN) CIRCUIT OPEN



Turn the ignition on.
Using a 12-volt test light connected to ground, check the (F921) Fused Ignition Switch Output (RUN) circuit at the Compass Module harness connector.

Does the test light illuminate brightly?

Yes


No

5. (Z916) GROUND CIRCUIT OPEN



Turn the ignition off.
Using a 12-volt test light connected to 12-volts, check the (Z916) Ground circuit at the Compass Module harness connector.

Does the test light illuminate brightly?

Yes


No