STANDARD PROCEDURE - PROGRAMMING THE SKREEM/WCM USING THE SCAN TOOL
CAUTION:
Read all notes and cautions for programming procedures.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES
- STANDARD PROCEDURE)
1.
Connect a battery charger to the vehicle.
2.
Connect the scan tool.
CAUTION:
If the ECM/PCM and SKREEM/WCM are replaced at the same time, the ECM/PCM MUST be programmed before the SKREEM/WCM.
3.
Select “ECU View”.
4.
Select “WCM Wireless Control Module”.
5.
Select “Miscellaneous Functions”.
6.
Select WCM replaced.
7.
Enter the PIN when prompted.
8.
Verify the correct information.