U0114-LOST COMMUNICATION WITH FINAL DRIVE MODULE

For a complete wiring diagram Refer to Section 8W.

When Monitored:

With the ignition on
Battery voltage between 10 and 16 volts
IOD fuse installed
TIPM is configured correctly

Set Condition:
Bus messages not received from the Totally Integrated Power Module (TIPM) for approximately 2 to 5 seconds.

Possible Causes

CAN B BUS CIRCUITS OPEN OR SHORTED

DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES

TIPM NOT CONFIGURED CORRECTLY

TOTALLY INTEGRATED CONTROL MODULE

MODULE THAT SET THIS DTC

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)

Diagnostic Test

1. VERIFY DTC IS ACTIVE

NOTE: Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

With the scan tool, read active DTCs.

Is this DTC active?

Yes

Go To 2

No

Refer to the Stored Lost Communication test procedure. Refer to the table of contents in this section.
Perform BODY VERIFICATION TEST – VER 1.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS

With the scan tool, read all active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes

Diagnose and repair the DTC. Refer to the Table of Contents for a complete list of the symptoms.
Perform BODY VERIFICATION TEST – VER 1.

No

Go To 3

3. VERIFY THAT THE TIPM IS ACTIVE ON THE BUS

Turn the ignition on.
With the scan tool, select Network Diagnostics.
Verify that the TIPM is active on the bus.

Is the TIPM active on the bus?

Yes

Go To 4

No

Refer to the Table of Contents located in this section for a no response test procedure.
Perform BODY VERIFICATION TEST – VER 1.

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS

With the scan tool, select Network Diagnostics.

Is there more than one module with active DTCs “Logged Against” the TIPM?

Yes

Replace/update the Totally Integrated Power Module in accordance with the service information.
Perform BODY VERIFICATION TEST – VER 1.

No

Replace/update the module that set this DTC in accordance with the service information
Perform BODY VERIFICATION TEST – VER 1.