Top Rated HVAC Pros for horizon hvac Phenix City, AL. Phone +1 334-298-1278. 24 Hour Calls. Guaranteed Services – Low Prices.

Contact Us

Riley Heating & Air Conditioning

1019 Knowles Rd, Phenix City, AL 36869, United States

Telephone

+1 334-298-1278

Hours

Mon-Sun, 8am – 9pm

Space pressure can be either favorable or negative with regard to outside the room. Favorable pressure takes place when there is more air being provided than exhausted, and is common to decrease the seepage of outside pollutants. Natural ventilation is a crucial factor in lowering the spread of airborne health problems such as tuberculosis, the acute rhinitis, influenza and meningitis.

Natural ventilation requires little maintenance and is inexpensive. An a/c system, or a standalone a/c unit, provides cooling and humidity control for all or part of a structure. Air conditioned buildings often have actually sealed windows, due to the fact that open windows would work versus the system planned to maintain continuous indoor air conditions.

The percentage of return air made up of fresh air can normally be manipulated by adjusting the opening of this vent. Typical fresh air intake is about 10%. [] Air conditioning and refrigeration are provided through the elimination of heat. Heat can be gotten rid of through radiation, convection, or conduction. Refrigeration conduction media such as water, air, ice, and chemicals are referred to as refrigerants.

It is essential that the cooling horsepower suffices for the location being cooled. Underpowered a/c system will lead to power wastage and ineffective usage. Appropriate horsepower is needed for any a/c installed. The refrigeration cycle utilizes 4 necessary elements to cool. The system refrigerant begins its cycle in a gaseous state.

From there it enters a heat exchanger (in some cases called a condensing coil or condenser) where it loses energy (heat) to the outdoors, cools, and condenses into its liquid stage. An (likewise called metering device) manages the refrigerant liquid to stream at the correct rate. The liquid refrigerant is gone back to another heat exchanger where it is allowed to evaporate, for this reason the heat exchanger is often called an evaporating coil or evaporator.

In the procedure, heat is taken in from inside and moved outdoors, resulting in cooling of the building. In variable environments, the system might consist of a reversing valve that changes from heating in winter season to cooling in summer. By reversing the flow of refrigerant, the heat pump refrigeration cycle is changed from cooling to heating or vice versa.

Free cooling systems can have very high effectiveness, and are sometimes combined with seasonal thermal energy storage so that the cold of winter can be used for summer season a/c. Typical storage mediums are deep aquifers or a natural underground rock mass accessed by means of a cluster of small-diameter, heat-exchanger-equipped boreholes.

The heat pump is added-in due to the fact that the storage acts as a heat sink when the system remains in cooling (as opposed to charging) mode, triggering the temperature to slowly increase during the cooling season. Some systems consist of an “economizer mode”, which is in some cases called a “free-cooling mode”. When saving money, the control system will open (totally or partially) the outside air damper and close (completely or partly) the return air damper.

When the outside air is cooler than the required cool air, this will permit the need to be satisfied without utilizing the mechanical supply of cooling (usually chilled water or a direct expansion “DX” unit), hence conserving energy. The control system can compare the temperature of the outdoors air vs.

In both cases, the outdoors air must be less energetic than the return air for the system to get in the economizer mode. Central, “all-air” air-conditioning systems (or plan systems) with a combined outside condenser/evaporator unit are typically installed in North American residences, offices, and public buildings, but are hard to retrofit (install in a building that was not created to receive it) since of the large duct required.

An alternative to packaged systems is the usage of separate indoor and outside coils in split systems. Split systems are preferred and widely used worldwide other than in The United States and Canada. In North America, divided systems are usually seen in property applications, but they are gaining appeal in small business structures.

The advantages of ductless a/c systems consist of easy installation, no ductwork, higher zonal control, versatility of control and peaceful operation. [] In area conditioning, the duct losses can account for 30% of energy intake. Using minisplit can lead to energy cost savings in space conditioning as there are no losses associated with ducting.

Indoor systems with directional vents mount onto walls, suspended from ceilings, or fit into the ceiling. Other indoor units mount inside the ceiling cavity, so that brief lengths of duct manage air from the indoor system to vents or diffusers around the rooms. Split systems are more effective and the footprint is usually smaller sized than the package systems.

Call Now