How To Build Wood Aquarium Stand,Making Wood Bowls Router Scroll Saw,Woodcraft Orlando,Woodworking Plans Wheelbarrow - Try Out

09.07.2014, admin  
Category: Woodworking Plans Boxes

The following article outlines the construction of a dimensional lumber and plywood aquarium stand. Plywood or other sheeting - The sheeting used for this project will have the most effect on final appearance of the aquarium stand.
After the basic frame is built, additional 2x4s are added to give a surface to nail the sheeting to. The next phase of the construction of the aquarium stand is to cover it with the sheeting of your choice. You can add other features such as shelves, lights or power strips to the inside of the stand to fit your needs.
When I built my 55 gallon aquarium stand, I was a little concerned about it being top heavy. When purchasing molding for an aquarium stand that you plan on staining, make sure the molding wood is of the same type as the sheeting.
Once again, make sure the wood is of the same type as the sheeting if you plan on staining. The doors should be of the same type of wood as the rest of the stand for staining purposes. The height of the aquarium stand is up to you, but most commercial aquarium stands around 32 to 36 inches high. These additional 2x4s are used on each of the vertical supports to give the stand frame a flat surface.


Make sure to sand all areas of the aquarium stand before applying the finish to get the best result.
To take care of this concern, I added a layer of 2x4s to the bottom of the stand and clad them with the same sheeting used to build the stand. Make sure when designing your aquarium stand plan that it will not be too tall to fit in the area you have planned to place it.
Once the finish is applied, the doors can be attached to the stand and the aquarium can be placed. Before purchasing the 2x4s, calculate how many you will need for the size of the aquarium stand you are building.
The length of molding needed can be estimated by looking at the aquarium stand plan for your particular aquarium size. These 2x4s should be cut to fit snugly between the upper and lower rectangles of the aquarium stand. The finish used should be designed for use with the material used to build the aquarium stand. In order to adjust the design for the aquarium size, you would simply have to adjust the length and width of the wooden pieces. Do some shopping around but remember that this is also the most visible portion of the aquarium stand. The aquarium stand I built for this plan was higher than most because I wanted the tank to have a higher line of sight.


The photo below shows some of the modifications I had to make to ensure the doors fit the stand properly and that they had a sound location on which to attach the hinges. The rear of the stand does not need to be covered unless it is in view or if you are planning on storing a lot of items in the stand. The photos that show the progress of the aquarium stand build are from my 120 gallon aquarium, unless otherwise specified. Remember that while thicker materials are typically sturdier, they are also heavier and will add a bit to the overall length and width of the aquarium stand. This article assumes that you possess basic carpentry skills and that you know how to measure, use power tools and glue.
You can hide the nail heads by counter sinking them with a punch and filling the holes with wood putty. If you not know proper safety precautions for working with power tools, you will need to consult a woodworking or carpentry book, or perhaps take carpentry classes.



Diy Firewood Storage Shed Plans
Coffee And End Table Sets Wood


Comments to “How To Build Wood Aquarium Stand”

  1. 8899:
    Likely be nice as a ornament in your toilet, especially highland Woodworking.
  2. ADRENALINE:
    Fields How To Build Wood Aquarium Stand in design & machining slightly than just cabinets for e book instances here is an example of a 'welsh.
  3. QIZIL_OQLAN:
    Parchment, or other supplies, fastened collectively to hinge at one.