How to Make Colloidal Silver

Want to know how to make colloidal silver? Read on for a complete step by step guide on how to make the substance at home...

Colloidal silver results when the molecular structure of silver is changed. The substance is then suspended in a liquid solution. Colloidal silver has been used for medicinal purposes for ages. The substance can be made at home following a few simple guidelines.

Essential supplies for making colloidal silver

In order to make colloidal silver at home you will require 6 volt DC transformers, two alligator clips and two pure silver coins. You will also require some distilled water and a fish tank oxygenation bubbler with at least 2 feet of neoprene tubing. Lastly you will need a glass quart jar and a small airtight glass container.

Making colloidal silver


Step 1

You will start off by gathering all your supplies together and making sure everything has been cleaned properly. Particular care must be taken to properly clean the silver coins that you will be using.

Step 2

Next up you will have to clip the plug off the DC connector towards the end of the transformer wire. You should leave the wall plug wire intact. You will work only on the cut wire and separate the wires from the strip. Ideally you should take around one inch of the insulation off. Make sure you don’t damage the wire.

Step 3

When you have the bare wires you will connect them to an alligator clip. You can either crimp them or solder them in order to secure them in the proper place. The silver coins come into play next. In this case the silver coins will be your two silver electrodes. You will need to clamp both these coins on opposite ends of the glass jar just alongside the alligator clamps.

Step 4

Next up you need to run the tubing towards the bottom of the jar and fill it up with a total of 8 oz. of the distilled water. The water should come up to the bottom of the clips. Be careful to let the metal on the clamp be above the surface of the water. This is because only the coins should be submerged in the distilled water.

Step 5

Once you have set up the equipment in this manner you should plug in the transformer along with the oxygenation unit in appropriate electrical outlets. Now you should leave the water to bubble for the next five hours.

Step 6

After the time has passed safely unplug the units and remove the coins. Make sure you thoroughly clean off any residue left from the experiment. These coins should be stored away safely as they are good enough to be used again. The two coins can help you to make greater quantities of colloidal silver than you will ever require. You can further purify the colloidal silver that you have obtained by siphoning it into a storage bottle using the tubing rather than pouring it. Following the above mentioned guidelines will help you to produce great amounts of colloidal silver with considerable ease at home.