Configuring the advanced settings
By default, the DS-Client is optimized for maximum performance. However, for users who have expert knowledge in managing their backup data, advanced parameters are available for further performance improvement. The parameters available depend on the type of DS-Client (Windows, Linux, or Mac).
When using a Windows Grid DS-Client, some parameters can be applied to an individual leaf node or globally to all the leaf nodes in the Grid DS-Client. All Windows DS-Client parameters are applied globally unless otherwise specified.
IMPORTANT: The default settings are sufficient to run any DS-Client. If you change a parameter, the DS-Client’s performance will be affected. Do not attempt to change these settings unless you have a specific requirement and have confirmed this with your service provider. Depending on the parameter modified, you might need to restart the DS-Client service for the changes to take effect.
To configure the advanced settings:
1. On the Setup menu, click Configuration.
2. Click the Advanced tab.
3. In the Category box, select the category containing the advanced parameter you want to configure.
4. In the Parameter box, select the advanced parameter you want to configure.
5. In the Value box, enter a value for the parameter, and then click OK.