Specifying the destination for VM replication
In the Choose Destination for Replication Set page, the DS-Client that has been grouped with the source DS-Client by your service provider will be shown in the Destination DS-Client list. IP addresses of multiple DS-Clients will be available for selection in this list if multiple DS-Clients have been grouped with the source DS-Client.
NOTE: Sufficient
VM Replication Capacity must be available before you can complete this step. See information on the prerequisite
“Licensing:”.
1. In the Destination DS-Client Info section, verify that the IP address shown beside Destination DS-Client represents the DS-Client you want to use. If necessary, select the IP address of another DS-Client in the list.
The IP address of the DS-Client that is shown will be the destination DS-Client acting for the replication target virtual machine in this VM replication set.
2. Verify that the port number displayed beside Destination Port represents the port used by the destination DS-Client.
3. In the Destination Hypervisor Info section, type the IP address of the destination Hyper-V Server as the Hypervisor IP.
The selected virtual machine(s) will be replicated to the destination Hyper-V Server.
4. Type the user name and password that are needed to access the destination Hyper-V Server (or click the Browse
... button to open a key file that contains the required user name and password) and then click
Next. For important recommendations, see
“Credentials for the source and destination servers:”.
The credentials you have entered are sent to the destination DS-Client, which then attempts to access the destination Hyper-V Server.