Sanding Wood By Hand,woodworking tool storage plans,woodworking class kenosha,Jet Planer Molder Parts - Review

Always sand with the grain of the wood, making long, light, even strokes with a padded sanding block. Sand lightly along the grain of the wood, pressing the paper into cutout areas with your fingertips.
Before you begin the work, make sure you know the basics.Sanding TechniqueThe first rule of sanding is to work with the grain of the wood, because cross-grain sanding can leave permanent and very obvious scratches. Between grades, brush off or vacuum up all dust and steel wool debris, then wipe the wood clean with a tack cloth.Raising the GrainWhen wood is moistened, the cells that make up the grain swell, raising the grain above the surface of the wood. The padding shapes itself to the curves, providing firm, even pressure.Good sanding technique is easy to learn and apply.
Any liquid causes this reaction; even when the wood is smoothly sanded, the finish itself acts to raise the grain. To prevent the appearance of a raised grain in the finished piece of furniture, the grain should be purposely raised and then sanded down before the finish is applied after the final sanding.The simplest grain-raiser is water.


Sponge the sanded piece of furniture with cold water, soaking the wood evenly and thoroughly; then wipe off any excess.
Change the sandpaper as soon as it clogs or wears smooth.To smooth the wood evenly and thoroughly, work with successively finer grades of sandpaper. The same thing is true for wood with a fine patina -- normal sanding will remove the patina. The wood must be evenly wet, with no dry spots and no puddles, or it may dry with water stains. The slight roughness left by the first sanding will be removed in the next sanding; the final sanding will remove the last traces of roughness.
Although finer-grit paper would theoretically produce a smoother surface, sanding with too fine a paper can clog the wood and interfere with finishing.Sand the entire piece of furniture with each grade of sandpaper before moving on to the next grade. Between sandings, brush off or vacuum up all sanding debris, and then wipe the wood clean with a tack cloth.


Dust or grit caught under the paper can scratch the wood.If there are tight corners you can't get at with sandpaper, use a very sharp scraper to very carefully smooth the wood in these. Hard sanding with coarse-grit paper, with or without a block, can flatten or deform round parts; only the minimum of wood should be removed.
Move up and down each round, changing your angle of sanding as you work to smooth the wood evenly. Be careful not to leave horizontal grooves in the wood at the edges of the sandpaper strips.



How To Make Money Woodworking From Home
Bunk Bed Ladder Only Target
Free Simple Garage Cabinet Plans
Woodworking Inlay Patterns