Build Your Own Drafting Table,Wooden Towel Stand Ikea,Diy Built In Cabinets Bedroom,Plans For Making Wooden Trains - You Shoud Know

19.02.2015
Plans to make a drafting table,small wooden runabout plans,how to make a wood stove fire last all night - . Also do the same for the connection of the top drafting table surface to the hinge by installing the separately provide top hinge mount to the dimensions specified.
It helps to have someone else hold the table when you attach it because of the angles but if your like me and have no friends then I suggest laying the entire table on the floor and putting some blocking under the table top (by the 2″ strips) to hold it up vertical. These dimensions should be measured from the 2 inch strips not the end of the drafting table bottom surface.
By installing these hinges it will take some unnecessary pressure off the architectural hinges and keeps the rotation point located directly at the front of the table so it won’t lift up from the front. It will consist of two legs that fold in and out so the table is able to rotate against the wall when not in use. I suggest that you take a chisel or a jig saw and cut out a section, equal to the depth of the hinges, off the 2″ strips (perpendicular to grain) so that the table can lay flat when closed. First and foremost before you start to build your own drafting table no project should go without a set of plans and details. As you see it will composed of two surfaces one that is the actual drafting surface and the other that is the base to connect the legs and wall too.


That being said here is the step by step instructions to Build your own Drafting Table for use in the office or at home. The trick here is to install the first leg (lets say the left side) located at the corner of the 2″ vertical strips near the front of the table. So, install the actual hinge to the bottom base piece and the hinge catcher to the underside of the drafting table surface.
Then we will need to cut the intermediate 2″ pieces for the drafting table surface to land upon.
Next, it is time to install the adjustable hinges to the drafting table surface and bottom piece. Note, these measurements are from the edge of the drafting table to center line of the leg post.
Here are some other drafting table designs that I though where also very interesting and well thought of. I installed four 2″ hinges spaced evenly across the front of the table instead of a solid piano hinge.
Now it is time to attach the the table top to the hinges and the Rockler architectural hinges.


So, basically here is my drafted plans, a scope if you may, of the drafting table to be constructed. And since you know what force it can withstand you can tell everyone that you built a Drafting Table That should hold!
The only items left are the folding legs, the ledger attachment to the wall and table, the paper stopper strip of quarter round and the stain (if you haven’t applied it already). It was a little taller than a normal table but I personally would like to be able to stand up and review plans as needed.
Before we put the two surfaces together we will need to install the hinges on the 2″ front piece and attach them to the drafting table surface. For my drafting table I applied (3) coats of stain sanding each time before applying the next coat thus ensuring a nice smooth finish.



Garden Tool Storage Plans
Free woodworking plans kreg jig
How To Strip Paint Off A Wood Garage Door
How To Build Wine Barrel Furniture Plans

Category: Furniture Projects



Comments to «Build Your Own Drafting Table»

  1. X5_Oglan writes:
    Richly textured look of pure wood, it's typically.
  2. SINDIRELLA writes:
    Must be about 1/2 inch thick (12 mm) inventive and check out a Build Your Own Drafting Table number of the like a storage.