22 Sep. 1994|
Wood stove building code,plans to build a wooden storage shed,making a woodworking vise part - Plans Download
A permit shall be obtained before beginning construction, alteration or repairs, other than ordinary repairs, using application forms furnished by the building official.
A building permit must be taken out prior to installation of a solid fuel stove (wood, coal, pellet, etc). 3 The stove must be located on a non-combustible floor or an approved floor protection material shall be placed under the stove.
4 Most stoves should be spaced out at least 36 inches away from any combustible material. 5 Floor protection must extend out 6 to 12 inches from the sides and back of the stove, and 18 inches where the stove is loaded or cleaned out.
8 There is at least 18 inches between the top of the stovepipe and the ceiling or other combustible material. 9 The stovepipe slopes upward toward the chimney and enters the chimney higher than the outlet of the firebox.
10 The stovepipe enters the chimney horizontally through a fireclay thimble that is higher than the outlet of the stove firebox.
13 A double-walled ventilated metal thimble is used where the stovepipe goes through the interior wall.
Be sure you are burning the proper type fuel for your stove and that it is of good quality. If you plan to have this type of generator installed, you may need to obtain an electrical permit from the Building Department. Ordinary repairs are nonstructural repairs and do not include addition to, alteration of, or replacement or relocation of water supply, sewer, drainage, drain leader, gas, soil, waste, vent or similar piping, electrical wiring, or mechanical or other work for which a permit is required by the building official.
One-story detached accessory structures used as tool and storage sheds, playhouses and similar uses, provided the floor area does not exceed 200 square feet (18.58 m2).
Sidewalks and driveways and on grade concrete or masonry patios not more than 30 inches above adjacent grade and not above any basement or story below. Steam, hot- or chilled-water piping within any heating or cooling equipment regulated by chapters 18 to 24 inclusive of the International Residential Building codes. The stopping of leaks in drains, water, soil, waste or vent pipe; provided, however, that if any concealed trap, drainpipe, water, soil, waste or vent pipe becomes defective and it becomes necessary to remove and replace the same with new material, such work shall be considered as new work and a permit shall be obtained and inspection made as provided in Sections R-105 and R-109 of the International Residential Code. The clearing of stoppages or the repairing of leaks in pipes, valves or fixtures, and the removal and reinstallation of water closets, provided such repairs do not involve or require the replacement or rearrangement of valves, pipes or fixtures. Where equipment replacements and repairs must be performed in an emergency situation, the permit application shall be submitted within the next working business day to the building official.
Application or notice to the building official is not required for ordinary repairs to structures, replacement of lamps or the connection of approved portable electrical equipment to approved permanently installed receptacles.
Rough framing, including, fire stopping, draft stopping and brace wall fastening along with rough plumbing, rough electric, and rough HVAC. If not, fire resistant materials, or heat shields, should be use to protect woodwork and other combustible surfaces. Exemption from permit requirements of this code shall not be deemed to grant authorization for any work to be done in any manner in violation of the provisions of this code or any other laws or ordinances of this jurisdiction.
If the stove is new, installation is in accordance with the manufacturer's specifications and installation instructions. Many new stoves have built in features that allow you to reduce the minimum clearance guidelines below. Other inspections including special inspections as determined by the Building Official and a Certicicate of Occupancy inspection.