04 May. 1997|
Wood routers uses,best woodworking projects beginner,philippine wood carving art - How to DIY
With the router unplugged and resting on a steady workbench, insert the desired bit into the collet. Some routers have a protective guard to shield the user from flying debris, but you should always wear safety goggles and a dust mask. Use an even speed when pushing the router across wood: If you go too fast the cut will be rough, but go too slowly and burn marks may appear. Fasten a support board to the bench to stabilize the router and a stop board to secure it so you don't need clamps. Cut only on the right side of the jig and push the router away from you; the turning direction of the router bit will pull the router base against the jig. The keys to routing clean edges are using a sharp bit and running the router in a counterclockwise direction around the top of the workpiece.
If the wood burns, sneak up on the final cut depth by making three consecutively deeper cuts (see photos, below). Clamps get in the way of the router and it's hard to keep the base from rocking on the narrow surface. If you rout on the left side of the jig, the router will tend to wander away from the jig and you'll wind up with a run-amuck dado. That way, the bit pushes the router toward you rather than pulling it away, so it's easier to control and safer. Some wood species ten to chip more than others, so run a test on a scrap board of the same species. They're available at home centers and woodworking stores individually or in kits (Photo 2) that allow you to swap pilot bearings to adjust the rabbet width with the same cutting bit.
That gives the router a wider surface to rest on, eliminating any rocking, and forces the workpiece against the support board and the stop, so it doesn't need clamps.
Plan and mark the dado locations on the workpiece, then line up the jig's groove with your layout marks, clamp the jig to the wood and dado away (Photo 2).