19 Dec. 2007|
Segmented woodturning tools,bamboo furniture making material,japanese hand saws wood,how to build a solid wood mantel - Reviews
The wood art of segmented wood turning is captivating as 90% of the work is spent in designing, dimensioning material, cutting, fitting, and gluing. Before I cut the staves for segmented woodturning, I always practiced making the angled cuts on the 10″ compound miter saw.
As a wood turner I look back on this segmented woodturning project and remember this moment of learning this woodcraft. The segmented woodturning design you create will determine how many segment rings your project will have along with how many segments will be included within each ring. Once you have the design worked out it is time for determining the cutting list for the segments of each ring. The saw blade I like to use for my mitresaw for segmented woodturning is a 10-inch 80 tooth Forrest Chopmaster.
Once the segmented woodturning is completely sanded and burnished the dust will be completely blown away with the aid of an air compressor.
It is one of those wood projects that requires more than just a wood lathe and some lathe tools.
This too can be done on paper, however the software for segmented woodturning becomes very convenient at this time. Often times I will simply glue all the segments of a ring at one time and then tighten a hose clamp around the ring. These two set-up tools are invaluable for segmented woodturning as they allow for very accurate results.
Lathe tools shape the segmented rings of cherry, maple, and walnut and this along with sanding creates a smooth surface for this woodturning project.
The entire woodturning process is fascinating yet it is critically important to get all of the joints aligning properly for a good tight fit. On the cover of this magazine was a unique segmented woodturning sculpture by a very talented segmented woodturner, Malcom Tibbets. Moreover, the making of these segmented bowls requires total attention to detail along with a commitment to accuracy from start to finish.
To create an even smoother surface the wood turner can grab some of the wood shavings and carefully hold it against the segmented woodturning project thus creating a burnished surface.
Then it’s just a matter of working off the cutlist until you have all of your segments cut and then organized so they can be glued into rings.
I’ll place the glue on the side of the segment and rub it with the adjoining segment while aligning the joint.
This was wood art that was quite extraordinary and it was easy to see that Malcolm was pushing the boundaries of woodturning. This not only provides strength for your segmented turning, but it provides for a pattern in the overall design.