31 Jan. 1975|
Poker table leg plans,diy wooden roof rack basket,encyclopedia wood joints pdf - .
Sand the side of the Table Top to remove any roughness or unevenness from sawing using a belt sander.
Apply a thin coat of polyurethane to the top side and edge of the table top, and to all sides of the rail. Once the vinyl is wrapped around the outside and stapled in place, take the utility knife and run it down inside edge of the rail and remove all of the excess vinyl.
If you prefer to stain you table, you may want to substitute for a different species of wood.
The table top will be 1 piece and the rail will consist of 3 pieces (top, middle and bottom).
Cut off a portion of each end of each leg to ensure that both ends of the leg have a finished cut. Drill 10 countersink pilot holes for each leg mount board; 3 holes on each side and 4 on the end. Have the legs tight up against the frame on the ends; leave an equal space between the legs and the side frames.