03 Dec. 1975|
Plywood edge banding veneer,woodworking adze uk,how to build a bunk bed,basic wood carving patterns - .
Hardwood edging can be a simple as gluing a wood strip to the edge of the plywood and flushing cutting the top edge to the plywood surface. If the project calls for a basic straight edge on the plywood, veneer edge banding may be just what the doctor ordered. Cut a piece of edge banding about 1" longer than the length of the panel that you are banding. If you are applying the edge banding to two joining sides, its best to work with the least visible side first. You should be able to see a small bead of adhesive expand out from the underside of the banding if the adhesive is activating. Leaving the iron in one place too long can result in burning the edge banding so be certain to keep the iron moving. If you are using a pre-finished edgebanding, place a cotton or flannel cloth over the edgebanding to prevent marring the finish. To trim the ends of the banding, it's easiest to stand the panel with the banded edge against a workbench. When the edge banding has cooled off, you can flush trim the top and bottom edges of the banding with any of several methods. A flush cutting router bit will do a fine job of trimming the edge banding but to use it, you'll need to stand the project panel on its edge which can be tricky for larger panels.
You can now lightly sand the top and bottom faces of the plywood where it meets the edge banding. Veneer edge banding can be stained and finished with any conventional wood finishing products including lacquer, danish oil, and oil based stain and polyurethane. If you want to have more options for dressing up the edges of your plywood projects, cover them with edging made from solid wood. Whichever of these methods you choose, adding edging will give your plywood projects a professional-quality appearance without adding a lot of expense. This method allows the builder to use a wide array of router bits to create a pleasing edge design. For example, if you are placing the edge banding around the 4 edges of a square or rectangular piece of plywood, start by edge banding the left and right sides then move on to the front and back sides of the material. To fix this, simply use the block of wood (held at a 45 degree angle) to press the edge back onto the substrate while the adhesive is still warm. Hold a 1" chisel tightly against the side edge of the panel and strike the chisel handle with a mallet. Simply press the trimmer against on to the face of the panel and slide it forward so that the blade cuts off the excess banding. Be sure to skew the chisel so that the pressure forces the banding against the wood edge as shown.
Iron-on banding is available from woodworking dealers and home centers in several wood species, and is easy to apply: Just iron it on, and then trim the edges and ends flush. If you're planning to use a dye or any high-penetration stain, you'll want to pay attention to splice lines in the edge banding. This will help hide the joint since the front and back edges will slightly overlap the edge of the sides. This method often leaves a bit of tear-out on the banding but the next step will smooth them out with very little effort.
Or if you prefer a micro-beveled edge, you can use a sharp block plane or sandpaper wrapped around a wood block.
Use scissors (for paperbacked veneer) or a veneer saw (for 2-ply and raw wood veneer) to cut your own edgebanding from the veneer stock used on the other parts of your veneered panel.
With heat from a clothes iron, you can bond any non-glued edgebanding, including one cut from a piece of veneer to any porous substrate.