17 Oct. 2010|
Planter boxes plans for herbs,hsc woodwork project ideas,changing table plans wood - How to DIY
Repeat this scenario about 5 or more times with different planter box ideas, and I finally ended up wearing him down. The conceptual idea for this garden structure came from that photo on Pinterest (and I quickly got frustrated trying to follow the links to dead ends.
If you are going to extend the width of this planter, you might want to consider adding a third stair stringer in the middle for support. Brace at the bottom good idea ,,but use biggest washer possible as small ones will tear thru plastic more easily,and use a sealant on the frame to increase life of the frame.,and if you dont already know,,place stones or chunks of broken concrete over drain holes to prevent plugging. Or, maybe it just took him a little while to realize how much he LOVED the idea…and LOVED the idea of constructing it for us. When the planter boxes are attached, drill additional holes in the bottom of the boxes to allow them to drain well. I don’t recall how they were held up but they shaded an area below for shade loving plants and, with holes in the gutter bottoms, any extra water ended up watering the plants below, like lettuce.
I am so happy we put ours together; I recently started up all 5 boxes with spring mix and basil.
I have grown lettuces and herbs in the containers so far, and it has worked very well for those! You have placed the planters with the angled side butted up to the square face of the riser.
If you had turned the planter around so that the square edge had fitted directly into the square face of the riser it would have looked and fitted a little better.
We decided to opt for the tall choice – it takes up less space on the ground, and the top planter hits at a little lower than my eye level. We placed 4 screws in each planter box; we started from the bottom and worked our way up the structure.
This is a wonderful space saving addition to the garden and a great idea, also, for a patio, with nothing else but flowers.
We placed the legs of our vertical planter on the inside of the structure, but you can also place them on the outside of the riser if preferred. Using the crosspieces mentioned above I am going to make a free standing unit to place next to my Tiki Bar.
However, if you choose this route, you will need to measure a longer piece for the back stabilizer to account for the added width of the structure.