18 May. 2013|
Make a picnic table diy,best wood carving knives for beginners,bay window bench seat ideas - For Outdoors
Monthly advice on how to make your home eco-friendly, including energy and water saving tips, healthy home products, green remodeling, and more, plus special offer. Design solutions, designer interviews, room makeovers, garden tips, video tours, sweepstakes news, and special offers.
This basic picnic table design calls for five cutting patterns only, making it low-cost and easy to build. We realize that not everyone has the time or the facilities to construct the "polygonal picnicker" described in Build a Hexagon Picnic Table. Following are instructions on how to build a 10 ft long by 4 ft wide picnic table with 6 moveable benches made out of Red Cedar and all stainless steel hardware and treated with 3 coats of Helsman Spar Urethane. Note that you will also have to cut the diagonal bracing underneath the table top, but it is best to scribe this board to fit after the rest of the top is fastened together. Lay out the top boards on sawhorses, setting them so the best side (least knots, cracks, etc) is down, since this will be the bottom of the table top. Nail the 2X4 boards with the 45 degree angle cuts to the bottom of the table top, spaced 4 inches (10 cm) from either end and the third centered between the ends.
Position the 35 inch (88,9 cm) 2X6s so they are centered over the short point of the table top end rails as shown in the photo, and nail them securely to the rails. Center the seat rails (also 2X6 72 inches - 183 cm - long), centered between the inverted table legs, resting on the nails you have driven in at 17 inches.
Cut the corners of the table top at a 45 degree angle about 2 inches (5 cm) from the corners so they are rounded, to make it less likely anyone will bump into them.
Use a weather and rot resistant lumber, or even a synthetic decking material for a long lasting table.
Adding legs to the picnic table: Use red cedar 4 x 4s to build the legs and to hold the extra weight of the oversized table. Attach the top support, centered on the end supports and the center tabletop board, as shown above.
Though I have to admit, I already have plans for a kids picnic table in a woodworking book. Here are the steps to build your own sturdy, functional picnic table on which to enjoy your meal.and good for parties.
Toenail these to hold them in position until the table is flipped over, when you can finish nailing the top. Lay your seat boards (again, 2X6s, 72 inches - 183 cm - long, on the seat rails that should be sticking out from beneath the table on each side. Since we were building so many tables, no one managed to keep close track of the number, but it looks to have been over 40! Her favorite article she’s worked on has been How to Make Leche Flan, and she’s proud of being a Featured Author.
Because the tables had to stand up to use by thousands of visitors, we were looking for durability, simple design, and low cost. Make each four-piece unit by positioning a tabletop support and a bench support beneath two legs, as shown in the accompanying illustration, and nail the components together.