13 Sep. 1974|
Diy refinishing wood floors,wood drift boats montana,free twin platform bed plans,refinish a cedar strip canoe - Test Out
Of course, the color of the paneled walls is very distracting and detracts from the beautiful floors, so I want to paint those ASAP.
On the other hand, if you want really light-colored floors, you’ll almost certainly have to use a water-based finish. Waterlox would be more comparable to a polyurethane, in that both Waterlox and polyurethane are used as a clear finish to protect wood. Waterlox actually makes a cleaner that you can use to mop the floor, but just plain vinegar and water will work also.
And don’t forget to check out my other post where I shared a few specific details and tips regarding sanding the floors. I didn’t fill any nail holes because one person who comments on a previous post said she liked the look of the nail holes on her floor, and regretted having her hubby fill most of the nail holes.
When we started the apartment renovation, I knew the hardwood floors would need to be refinished.
I dipped my Purdy brush into the can of Minwax stain, tapped off the extra and applied the stain in a corner, working along the baseboard along the length of the wood plank.
Sounds like I ended up at Grandmother’s place (over the river and through the woods) and a lot quicker than it actually took. My most UN-favorite part: once the first coat is dry, lightly sand the entire floor with a 220 grit sandpaper. I was beginning to think that this hardwood floor refinishing project would never be complete, like I was caught in some Groundhog Day-type loop of never ending sanding. The color you see is the natural color that the wood turns when you apply an oil-based finish. In fact, the day before I applied the first coat of Waterlox, I actually wiped down then entire floor with mineral spirits, and they turned almost exactly that color with just mineral spirits. The difference is that polyurethane is literally a plastic coating that sits on top of the wood. Once the steps to strip the old finish was completed and floors and sawdust were cleaned up, we were ready to refinish the original hardwood for a new look. I applied the stain on a Friday and returned the following week to resume refinishing by sealing the floors.
So wiping mineral spirits onto wood is actually a very good way to see what color it’ll turn once an oil-based finish is applied, so you can determine of you want or need to use stain or not.
Waterlox is a tung oil-based finish that actually penetrates into the wood, much like the oil finishes (tung oil, linseed oil, etc.) that have been used to protect wood for over 200 years. If the scratches don't go all the way through to the wood, you can scuff-sand your floors with a buffer and apply a fresh coat or two of finish.
The process is easier and less expensive than sanding down to bare wood and takes less time. With either finish, I recommend a fresh coat every two years or whenever the floor looks worn.