10 Dec. 2011|
Deck stair plans landing,free wood carport plans with material list,build a dining table plans,furniture craftsman atlanta - Within Minutes
Calculating the step dimensions, laying out stringers and building a sturdy set of deck stairs. Picture a stair slope in your mind to estimate about a 40-degree slope and guess at a landing point.
Whether you're replacing an old, rickety set of deck stairs or building a set for your new deck, deck stairs are among the most challenging projects for the average do-it-yourselfer to tackle. One little mistake in calculations or layout and you'll wind up wasting lots of expensive wood, or worse, you'll build a downright dangerous set of stairs. But building a strong, safe set of stairs is doable if you meticulously follow the layout and cutting rules outlined in this story. You almost always have to design site-built stairs yourself because the number and height of the steps will vary with the landscape. For extra-strong stairs, reinforce the middle 2x10 stringer with 2x4s nailed to both sides (Photo 7). Top Tip: Building deck rails can be done in several ways, so you should study the alternatives and choose the most convenient option for your needs. Afterwards, you should fit the stringers into place and mark the place where they meet the ground.
Top Tip: Make sure you place the stringers equally spaced, if you want to provide a proper support to the stairs.
Continue the woodworking project by securing the other end of the stringers to the concrete landing pad.
But in this story, we'll make it easy by showing you how to estimate step dimensions, layout and cut stair stringers, and assemble the stair parts. B) to confirm the plan in your mind and lay out the first stringer (Photos 2 and 3) using the exact riser and tread dimensions and your framing square. The base can be a small concrete slab, a small deck or even a treated 2x12 leveled in over a 6-in. Test fit the stringer by placing it against the deck, and check the tread level with a small level. In addition, if the stairs are wider than 36″, you need to install a middle stringer, to support the weight of the structure properly. Make sure the proportions are accurate, otherwise the stringers won’t fit into place properly. It is essential to pour a concrete landing pad, as to secure the stringers into place tightly.
If necessary, place a piece of 2×6 lumber under the joists, as to increase the support surface. If you want to see more outdoor plans, we recommend you to check out the rest of the projects.
Start by estimating where you think the last stair will fall by using a 40-degree slope (Photo 1).
Photo 8 shows a simple, foolproof, extra-strong method that works especially well even for open-sided stairs built without skirts. These DIY steps will work for replacing an old set of stairs and for building stairs on a brand new deck. Lay out the stairs by drawing on the outside of the square, sliding the square along until it meets the last mark. That usually means going through the calculations a few times to determine where the stairs will fall and to figure out how long your skirt and stringer material needs to be. Rest a straight board on the deck and level over to that spot and measure down to the ground.
This will change the number of treads and shift the landing point, so re-measure the exact height and divide again. From this point, you can measure the exact stair height and determine the stringer and skirt length.